Satisfaction is always guaranteed! Call The Drain Surgeon on 0437 000 257.
Hot Water Servicing, Hot Water Replacement & Hot Water Repairs Mount Nasura
There are many reasons why you may lose your hot water supply. It may be as simple as a pilot light which has gone out to a burst hot water pipe, a valve or unfortunately you may need a completely new hot water unit.
A very common problem with hot water issues is a faulty tempering valve. A tempering valve is installed with most hot water units. The valve mixes the hot water with cold water to reduce the temperature at your taps to 50 degrees to prevent scalding. When the valve is not working correctly you may only have lukewarm water or poor hot water pressure.
Another cause of problems with your hot water may be that your pilot light has gone out. This often happens in winter with storms and strong winds. Your gas valve or thermocouple may also be faulty if you are unable to re light the pilot. Sometimes it may be a simple clean to get it working again. Insufficient gas pressure can also cause problems with your hot water supply.
A burst hot water pipe will result in poor hot water pressure and temperature. The hot water will be escaping into the ground where the pipe has burst. Pipes usually burst due to corrosion.
Aging hot water tanks begin to leak with corrosion on the inside of the tank. Most of the time the hot water units have not been correctly maintained over their life span for example changing over of the sacrificial anode which is located in the tank. Manufacturers recommend changing the anode to combat corrosion and extend the life of your storage hot water unit.
We can advise you on how to correctly maintain your unit and which unit would be your most cost-effective option to install and run.
Avoid cold showers this winter. Call The Drain Surgeon Plumbing & Gas for all your hot water requirements.
Nobody likes getting home after a long day at work to discover there’s no hot water.
The Drain Surgeon Plumbing & Gas specialises in gas, electric & solar hot water service repairs, replacements and installations for domestic and commercial clients in Mount Nasura and the surrounding areas. We can change over your existing gas, electric, solar or heat-pump hot water systems or replace like with like.
We replace all major brands, including Aquamax, Rheem, Rinnai, Bosch, Thermann, Vulcan and Dux.
The Drain Surgeon Plumbing and Gas was founded by Mark Ryan. Mark is a qualified plumber and gas fitter with over 20 years’ experience in the industry. So plumbing is not just a job to him, it’s his passion!
Mark’s vision was to provide the customers of Perth with a premium, no-nonsense service in both the residential and commercial sectors.
If you have problems with your hot water unit and you want a fast, efficient, and proven solution, give us a call.
Get in Touch
We're here to help you with all yout hot water requirements in Mount Nasura.
Why Choose The Drain Surgeon Plumbing & Gas?
- We are fully qualified, licensed and insured.
- Over 20 years of experience in the industry.
- We take pride in our work and ensure we leave the job as clean as we found it, if not better than we found it.
- We believe in an honest approach. We don’t try and upsell and will only repair what is necessary and advise honestly.
- Service with integrity.
Give us a call or send us an email with your problems and we'll give you a free estimation as soon as possible!
We charge a low fixed hourly rate. Don't get ripped off. Call us today!